From: marex@denx.de (Marek Vasut) Date: Wed, 4 Dec 2013 16:45:20 +0100 Subject: [PATCH RFC] PCI: imx6: remove outbound io/mem ATU region mapping In-Reply-To: <0E83723C55F66F43A6041464FE31119D47AB51@039-SN2MPN1-013.039d.mgd.msft.net> References: <1382504143-27915-1-git-send-email-tharvey@gateworks.com> <201312031019.58708.marex@denx.de> <0E83723C55F66F43A6041464FE31119D47AB51@039-SN2MPN1-013.039d.mgd.msft.net> Message-ID: <201312041645.21028.marex@denx.de> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Wednesday, December 04, 2013 at 03:38:49 AM, Richard Zhu wrote: [...] > > > [Richard] One Pericom PI7C9X2G303EL pcie switch, and two pcie ep > > > deivces(one is intel e1000e nic, the other is one xhci device) are > > > tested on imx6q sabresd board. > > > > How/what does have such pericom switch and can be attached to an MX6 > > sabresdp ? Where can I get it? > > [Richard] You can apply the example from Pericom. Which one? Please point me to a website or something here. > > > Without removing outbound io/mem regions view map during the cfg0/1 > > > read/write cycle, both of these devices can't work well at my side. > > > Works well after remove them during the cfg0/1 read/write cycles. > > > > Understood. Given that the iATU programming works on other CPUs > > (confirmed on st spear and ti dra7xx), we might have some issues with > > the iATU on MX6 . Is there anything special about the iATU on the MX6 ? > > [Richard] As I know that there is no anything special about the iATU on > MX6. Let me to make a double check with IC team later. Oh this would be absolutelly _amazing_ if you could do that. Thank you very much! [...] Best regards, Marek Vasut