From: Wolfgang Denk Date: Mon, 09 Dec 2013 21:12:02 +0100 Subject: [U-Boot] Creating U-Boot env image In-Reply-To: <52A5D4F1.7020101@xtech2.lv> References: <52A5D4F1.7020101@xtech2.lv> Message-ID: <20131209201202.A64B5380A65@gemini.denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Dear Alexey Smishlayev, In message <52A5D4F1.7020101@xtech2.lv> you wrote: > > I would like to flash the environment variable values to my board, > rather than setting them at the prompt. I've founa a tool mkenvimage is > made specially for that. I used it to create a binary image of the > U-Boot environment. However, when I flash it to my board, I get the message > *** Warning - bad CRC, using default environment > > I thought it is due to that redundant memory wasn't written aswell, so I > commented out #define CONFIG_ENV_REDUND_OFFSET in the > include/configs/at91sam9g20ek.h, and tried once again, but I'm still > getting this error. > > What should I do to flash environment values directly to the board's NAND? Why don't you just use "env import"? Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de Living on Earth may be expensive, but it includes an annual free trip around the Sun.