From: heiko@sntech.de (Heiko =?utf-8?q?St=C3=BCbner?=) Date: Fri, 13 Dec 2013 13:57:19 +0100 Subject: [PATCH 01/12] ARM: S3C24XX: cpufreq-utils: don't write raw values to MPLLCON when using ccf In-Reply-To: <201312131356.40755.heiko@sntech.de> References: <201312131356.40755.heiko@sntech.de> Message-ID: <201312131357.19899.heiko@sntech.de> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org The s3c24xx cpufreq driver needs to change the mpll speed and was doing this by writing raw values from a translation table into the MPLLCON register. Change this to use a regular clk_set_rate call when using the common clock framework and only write the raw value in the samsung_clock case. Signed-off-by: Heiko Stuebner --- arch/arm/mach-s3c24xx/cpufreq-utils.c | 13 +++++++++++++ 1 file changed, 13 insertions(+) diff --git a/arch/arm/mach-s3c24xx/cpufreq-utils.c b/arch/arm/mach-s3c24xx/cpufreq-utils.c index 2a0aa56..680a031 100644 --- a/arch/arm/mach-s3c24xx/cpufreq-utils.c +++ b/arch/arm/mach-s3c24xx/cpufreq-utils.c @@ -14,6 +14,7 @@ #include #include #include +#include #include #include @@ -60,5 +61,17 @@ void s3c2410_cpufreq_setrefresh(struct s3c_cpufreq_config *cfg) */ void s3c2410_set_fvco(struct s3c_cpufreq_config *cfg) { +#ifdef CONFIG_SAMSUNG_CLOCK __raw_writel(cfg->pll.driver_data, S3C2410_MPLLCON); +#endif + +#ifdef CONFIG_COMMON_CLK + struct clk *mpll = clk_get(NULL, "mpll"); + if (IS_ERR(mpll)) + return; + + clk_set_rate(mpll, cfg->pll.frequency); + + clk_put(mpll); +#endif } -- 1.7.10.4