From: horms@verge.net.au (Simon Horman) Date: Tue, 17 Dec 2013 09:30:28 +0900 Subject: [PATCH] ARM: shmobile: koelsch: Conditionally select MICREL_PHY In-Reply-To: <52AEFF56.5010602@cogentembedded.com> References: <1387153872-8387-1-git-send-email-horms+renesas@verge.net.au> <52AEFF56.5010602@cogentembedded.com> Message-ID: <20131217003028.GE27171@verge.net.au> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Mon, Dec 16, 2013 at 05:25:42PM +0400, Sergei Shtylyov wrote: > Hello. > > On 16-12-2013 4:31, Simon Horman wrote: > > >The koelsch board uses has an SH ethernet controller which uses a Micrel > >phy. Select MICREL_PHY for koelsch if SH_ETH is enabled to make use of the > >Micrel-specific phy driver rather than relying on the generic phy driver. > > Frankly speaking, I'm seeing no advantages to doing that. I think there is an advantage to using the hardware-specific driver. Even if it make any difference at run-time with the present code. > >Signed-off-by: Simon Horman > > Analogous changes are needed for BOCK-W and Lager boards since > they all use the same KSZ8041RNLI PHY chip. I was going to submit > such changes with the PHY IRQ patches but since no IRQ is generated > still, this got delayed... I believe that similar changes are needed for almost all of the shmobile boards. If you would like to handle some or all of them that is quite fine by me.