From: horms@verge.net.au (Simon Horman) Date: Tue, 17 Dec 2013 09:31:07 +0900 Subject: [PATCH] ARM: shmobile: koelsch: Conditionally select MICREL_PHY In-Reply-To: <52AF8D57.7010705@cogentembedded.com> References: <1387153872-8387-1-git-send-email-horms+renesas@verge.net.au> <52AEFF56.5010602@cogentembedded.com> <52AF8D57.7010705@cogentembedded.com> Message-ID: <20131217003107.GF27171@verge.net.au> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Tue, Dec 17, 2013 at 02:31:35AM +0300, Sergei Shtylyov wrote: > On 12/16/2013 04:25 PM, I wrote: > > >>The koelsch board uses has an SH ethernet controller which uses a Micrel > >>phy. Select MICREL_PHY for koelsch if SH_ETH is enabled to make use of the > >>Micrel-specific phy driver rather than relying on the generic phy driver. > > > Frankly speaking, I'm seeing no advantages to doing that. > > Although wait, Geert has reported the absence of Rx FIFO overflow > messages with this PHY driver, IIRC. > > >>Signed-off-by: Simon Horman > > > Analogous changes are needed for BOCK-W and Lager boards since they all > >use the same KSZ8041RNLI PHY chip. I was going to submit such changes with the > >PHY IRQ patches but since no IRQ is generated still, this got delayed... > > Only I was going to do it via defconfigs... That was my initial approach too. However I have been convinced that Kconfig is a better way forwards.