From: andrew@lunn.ch (Andrew Lunn) Date: Tue, 25 Feb 2014 19:53:17 +0100 Subject: [PATCH v3 5/5] ARM: kirkwood: Add HP T5325 devices to {multi|mvebu}_v5_defconfig In-Reply-To: <6144493.7kns7zvPT9@wuerfel> References: <1393349643-6652-1-git-send-email-andrew@lunn.ch> <1393349643-6652-6-git-send-email-andrew@lunn.ch> <6144493.7kns7zvPT9@wuerfel> Message-ID: <20140225185317.GA6762@lunn.ch> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Tue, Feb 25, 2014 at 07:19:33PM +0100, Arnd Bergmann wrote: > On Tuesday 25 February 2014 18:34:03 Andrew Lunn wrote: > > The HP T5325 has a PCI based VGA controller. Add the frame buffer > > driver, and frame buffer support to the defconfig's. Additionally > > add the soc audio framework and the necessary codec. > > > > Signed-off-by: Andrew Lunn > > > Does the VGA console still work with the new PCI driver? I've not plugged in a monitor, but i do see: xgifb 0000:01:00.0: Relocate IO address: 10000 [00010030] PCI: enabling device 0000:00:01.0 (0140 -> 0143) xgifb 0000:01:00.0: chipid = 32 xgifb: SR14=51 DramSzie 2000000 ChannelNum 1 xgifb 0000:01:00.0: Framebuffer at 0xe0000000, mapped to 0xe1000000, size 32768k xgifb 0000:01:00.0: MMIO at 0xe4000000, mapped to 0xe0a00000, size 256k xgifb 0000:01:00.0: No or unknown bridge type detected xgifb: Default mode is 800x600x16 (60Hz) so it looks like the frame buffer is happy. I will see if i can find a cable and a monitor. Andrew