From: jason@lakedaemon.net (Jason Cooper) Date: Sun, 14 Sep 2014 05:01:41 -0400 Subject: [PATCH 0/2] irqchip: gicv3: add initial CPU PM support In-Reply-To: <1409065415-20176-1-git-send-email-sudeep.holla@arm.com> References: <1409065415-20176-1-git-send-email-sudeep.holla@arm.com> Message-ID: <20140914090141.GZ21986@titan.lakedaemon.net> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Tue, Aug 26, 2014 at 04:03:33PM +0100, Sudeep Holla wrote: > From: Sudeep Holla > > This patch series adds initial support for CPU power management with GICv3. > > When a CPU enters a low power state, the GICv3 system registers are lost. > They need to be saved and restored if required. Currently as the GICv3 > system configuration register are not modified at runtime, the patch > just re-initialise to initial values. > > This series only supports CPU power states. However, for system power > states, we may need to save and restore states of distributor and > re-distributors additionally. > > Currently this is tested only on models, testing on real hardware is > much appreciated. > > Regards, > Sudeep > > Sudeep Holla (2): > GICv3: refactor gic_enable_redist to support both enabling and > disabling > GICv3: implement CPU PM notifier > > drivers/irqchip/irq-gic-v3.c | 87 +++++++++++++++++++++++++++++++++----------- > 1 file changed, 66 insertions(+), 21 deletions(-) Series applied to irqchip/gic with Marc's Ack. thx, Jason.