From: Tom Rini Date: Fri, 10 Oct 2014 10:40:03 -0400 Subject: [U-Boot] [U-Boot, 1/4] ahci: Don't start command DMA engine before buffers are set In-Reply-To: <1411484824-27265-2-git-send-email-rogerq@ti.com> References: <1411484824-27265-2-git-send-email-rogerq@ti.com> Message-ID: <20141010144003.GV25506@bill-the-cat> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On Tue, Sep 23, 2014 at 06:07:01PM +0300, Roger Quadros wrote: > The DMA/FIS buffers are set in ahci_port_start() which is called > after ahci_host_init(). So don't start the DMA engine here > (i.e. don't set FIS_RX) > > This fixes the following error at kernel boot on OMAP platforms (e.g. DRA7x) > WARNING: CPU: 0 PID: 0 at drivers/bus/omap_l3_noc.c:147 l3_interrupt_handler+0x260/0x358() > 44000000.ocp:L3 Custom Error: MASTER SATA TARGET GPMC (Idle): Data Access in User mode during Functional access > > Signed-off-by: Roger Quadros Applied to u-boot/master, thanks! -- Tom -------------- next part -------------- A non-text attachment was scrubbed... Name: signature.asc Type: application/pgp-signature Size: 836 bytes Desc: Digital signature URL: