From: linux@arm.linux.org.uk (Russell King - ARM Linux) Date: Thu, 14 May 2015 16:20:32 +0100 Subject: [PATCH] Show proper respect for Heinrich Hertz by using the correct unit for frequency In-Reply-To: <5551217C.9090504@suse.de> References: <20150511131952.GD2067@n2100.arm.linux.org.uk> <5551217C.9090504@suse.de> Message-ID: <20150514152032.GA29132@n2100.arm.linux.org.uk> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Mon, May 11, 2015 at 11:39:08PM +0200, Andreas F?rber wrote: > Am 11.05.2015 um 15:19 schrieb Russell King - ARM Linux: > > The SI unit of frequency is Hertz, named after Heinrich Hertz, and is > > given the symbol "Hz" to denote this. "hz" is not the unit of frequency, > > and is in fact meaningless. > > > > Fix arch/arm to correctly use "Hz", thereby acknowledging Heinrich Hertz > > contribution to the modern world. > > > > Signed-off-by: Russell King > > Nice. :) Since you're being exact, should it be "Hertz' contribution"? > > > diff --git a/arch/arm/boot/dts/omap3-cm-t3517.dts b/arch/arm/boot/dts/omap3-cm-t3517.dts > > index f5b5a1d96cd7..53ae04f9104d 100644 > > --- a/arch/arm/boot/dts/omap3-cm-t3517.dts > > +++ b/arch/arm/boot/dts/omap3-cm-t3517.dts > > @@ -66,7 +66,7 @@ > > > > otg_drv_vbus: pinmux_otg_drv_vbus { > > pinctrl-single,pins = < > > - OMAP3_CORE1_IOPAD(0x2210, PIN_INPUT_PULLDOWN | MUX_MODE0) /* rmii_50Mhz_clk.usb0_drvvbus */ > > + OMAP3_CORE1_IOPAD(0x2210, PIN_INPUT_PULLDOWN | MUX_MODE0) /* rmii_50MHz_clk.usb0_drvvbus */ > > This one looks like an identifier - did you check where it comes from > and whether it needs to be fixed there as well? There isn't any other reference to it in arch/arm (if there were, the grep to find these would itself have found it.) -- FTTC broadband for 0.8mile line: currently at 10.5Mbps down 400kbps up according to speedtest.net.