From: Tom Rini Date: Fri, 19 Jun 2015 16:25:31 -0400 Subject: [U-Boot] ARM: DRA7: Change configuration to prevent DDR reset control from EMIF In-Reply-To: <1434461341-21565-1-git-send-email-nm@ti.com> References: <1434461341-21565-1-git-send-email-nm@ti.com> Message-ID: <20150619202531.GG28577@bill-the-cat> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On Tue, Jun 16, 2015 at 08:29:01AM -0500, Nishanth Menon wrote: > DRA7/AM57xx devices can be operated in many different configurations. > When the SoC is supposed to support a configuration where low power mode > state may involve the SoC completely powered off and DDR is in self > refresh, SoC EMIF controller should not be the master of the reset > signal and an external entity might be in control of things. > > The default configuration of Linux on TI evms involve not powering off > the voltage rails (due to various reasons including reliability concerns) > and must not allow DDR reset to be controlled by EMIF. On platforms > where external entity might control the reset signal, this configuration > will be a "dont care". > > Fixes: 536d87470869 ("ARM: DRA7: Update DDR IO registers") > Tested-by: Keerthy > Acked-by: Brad Griffis > Signed-off-by: Nishanth Menon > Reviewed-by: Tom Rini Applied to u-boot/master, thanks! -- Tom -------------- next part -------------- A non-text attachment was scrubbed... Name: signature.asc Type: application/pgp-signature Size: 836 bytes Desc: Digital signature URL: