From: Arthur LAMBERT Date: Wed, 1 Jul 2015 09:55:34 +0200 Subject: [Buildroot] [PATCH v3 1/1] board: add support for WarPboard In-Reply-To: <20150630232941.5a2a1b2e@free-electrons.com> References: <1435324405-26828-1-git-send-email-lambertarthur22@gmail.com> <20150630232941.5a2a1b2e@free-electrons.com> Message-ID: <20150701075534.GA16185@arthur-dreem> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: buildroot@busybox.net Le Tuesday 30 Jun 2015 ? 23:29:41 (+0200), Thomas Petazzoni a ?crit : > Dear Arthur LAMBERT, > > On Fri, 26 Jun 2015 15:13:25 +0200, Arthur LAMBERT wrote: > > This is a set of patch to add support for warpboard (Freescale board based on imx6sl) > > > > The patch contains : > > - defconfig for warpboard > > - linux patches from Fabio Estevam to fix device tree due to last change on warpboard schematics (rev 1.12) > > and to fix kernel imx_v6_v7 defconfig which use incorrect hci protocol > > - specific firmware file for warpboard bluetooth (nvram : brcmfmac4330-sdio.txt) > > That's a detail, but the commit log should be wrapped to 80 columns. > > > I will fix that > > +- transfer uboot into flash by running this command in host side: > > + $ sudo dfu-util -D output/images/u-boot.imx -a boot > > So maybe you should build the host-dfu-util package of Buildroot by > selecting it in the Buildroot defconfig, and use it here? > Very legit request. > > +- remove power and put warpboard into normal boot mode by opening the jumper. > > + > > +Update linux & rootfs > > +===================== > > + > > +Use ums command from uboot prompt to mount emmc as mass storage and update zImage, device tree and rootfs file > > Which rootfs file? The tarball or the ext2 one? I will add more detail in this section > > > +Enable bluetooth (need to enable bluez-util) > > +================ > > +hciattach /dev/ttymxc4 any > > +hciconfig hci0 up > > Maybe: > > Using Bluetooth > =============== > > Enable the bluez_utils package, and then: > > $ hciattach /dev/ttymxc4 any > $ hciconfig hci0 up > > Of course, make sure you're really talking about bluez_utils or > bluez_utils5, we have two separate packages in Buildroot. > Both version are working great. > Could you take into account those minor comments, and send an updated > version? > No problem, V4 is coming ! > Thanks! > > Thomas > -- > Thomas Petazzoni, CTO, Free Electrons > Embedded Linux, Kernel and Android engineering > http://free-electrons.com