From: mst@redhat.com (Michael S. Tsirkin) Date: Thu, 16 Jul 2015 09:13:37 +0300 Subject: [Ksummit-discuss] [TECH TOPIC] IRQ affinity In-Reply-To: <20150715184800.GL13681@linux.intel.com> References: <20150715120708.GA24534@infradead.org> <55A67F11.1030709@sandisk.com> <55A697A3.3090305@kernel.dk> <20150715184800.GL13681@linux.intel.com> Message-ID: <20150716075454-mutt-send-email-mst@redhat.com> On Wed, Jul 15, 2015@02:48:00PM -0400, Matthew Wilcox wrote: > On Wed, Jul 15, 2015@11:25:55AM -0600, Jens Axboe wrote: > > On 07/15/2015 11:19 AM, Keith Busch wrote: > > >On Wed, 15 Jul 2015, Bart Van Assche wrote: > > >>* With blk-mq and scsi-mq optimal performance can only be achieved if > > >> the relationship between MSI-X vector and NUMA node does not change > > >> over time. This is necessary to allow a blk-mq/scsi-mq driver to > > >> ensure that interrupts are processed on the same NUMA node as the > > >> node on which the data structures for a communication channel have > > >> been allocated. However, today there is no API that allows > > >> blk-mq/scsi-mq drivers and irqbalanced to exchange information > > >> about the relationship between MSI-X vector ranges and NUMA nodes. > > > > > >We could have low-level drivers provide blk-mq the controller's irq > > >associated with a particular h/w context, and the block layer can provide > > >the context's cpumask to irqbalance with the smp affinity hint. > > > > > >The nvme driver already uses the hwctx cpumask to set hints, but this > > >doesn't seems like it should be a driver responsibility. It currently > > >doesn't work correctly anyway with hot-cpu since blk-mq could rebalance > > >the h/w contexts without syncing with the low-level driver. > > > > > >If we can add this to blk-mq, one additional case to consider is if the > > >same interrupt vector is used with multiple h/w contexts. Blk-mq's cpu > > >assignment needs to be aware of this to prevent sharing a vector across > > >NUMA nodes. > > > > Exactly. I may have promised to do just that at the last LSF/MM conference, > > just haven't done it yet. The point is to share the mask, I'd ideally like > > to take it all the way where the driver just asks for a number of vecs > > through a nice API that takes care of all this. Lots of duplicated code in > > drivers for this these days, and it's a mess. > > Yes. I think the fundamental problem is that our MSI-X API is so funky. > We have this incredibly flexible scheme where each MSI-X vector could > have its own interrupt handler, but that's not what drivers want. > They want to say "Give me eight MSI-X vectors spread across the CPUs, > and use this interrupt handler for all of them". That is, instead of > the current scheme where each MSI-X vector gets its own Linux interrupt, > we should have one interrupt handler (of the per-cpu interrupt type), > which shows up with N bits set in its CPU mask. It would definitely be nice to have a way to express that. But it's also pretty common for drivers to have e.g. RX and TX use separate vectors, and these need separate handlers. > _______________________________________________ > Ksummit-discuss mailing list > Ksummit-discuss at lists.linuxfoundation.org > https://lists.linuxfoundation.org/mailman/listinfo/ksummit-discuss