From: marex@denx.de (Marek Vasut) Date: Wed, 22 Jul 2015 15:43:54 +0200 Subject: [PATCH v2 2/5] Documentation: mtd: add a DT property to set the number of dummy cycles In-Reply-To: <8119e3b46b91e43c10466b2400c6938a113b1c02.1437569902.git.cyrille.pitchen@atmel.com> References: <8119e3b46b91e43c10466b2400c6938a113b1c02.1437569902.git.cyrille.pitchen@atmel.com> Message-ID: <201507221543.54761.marex@denx.de> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Wednesday, July 22, 2015 at 03:17:07 PM, Cyrille Pitchen wrote: > Depending on the SPI clock frequency, the Fast Read op code and the > Single/Dual Data Rate mode, the number of dummy cycles can be tuned to > improve transfer speed. > The actual number of dummy cycles is specific for each memory model and is > provided by the manufacturer thanks to the memory datasheet. > > Signed-off-by: Cyrille Pitchen > --- > Documentation/devicetree/bindings/mtd/jedec,spi-nor.txt | 6 ++++++ > 1 file changed, 6 insertions(+) > > diff --git a/Documentation/devicetree/bindings/mtd/jedec,spi-nor.txt > b/Documentation/devicetree/bindings/mtd/jedec,spi-nor.txt index > 2bee68103b01..4387567d8024 100644 > --- a/Documentation/devicetree/bindings/mtd/jedec,spi-nor.txt > +++ b/Documentation/devicetree/bindings/mtd/jedec,spi-nor.txt > @@ -19,6 +19,11 @@ Optional properties: > all chips and support for it can not be detected at > runtime. Refer to your chips' datasheet to check if this is supported by > your chip. > +- m25p,num-dummy-cycles : Set the number of dummy cycles for Fast Read > commands. + Depending on the manufacturer > additional dedicated + commands are sent to the > flash memory so the + controller and the memory > can agree on the number of + dummy cycles to use. Can't you just try negotiating this value at probe time, starting with some high value and see how low you can get with the negotiations ? This way, you'd be able to effectively auto-detect this value at probe-time. I might be wrong though :) Best regards, Marek Vasut