From: linux@arm.linux.org.uk (Russell King - ARM Linux) Date: Thu, 6 Aug 2015 16:26:54 +0100 Subject: IRQ setup on multicore systems (routing, balancing, etc) In-Reply-To: <55C37A72.2090507@free.fr> References: <55C0C102.7050600@free.fr> <55C37A72.2090507@free.fr> Message-ID: <20150806152654.GF7557@n2100.arm.linux.org.uk> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Thu, Aug 06, 2015 at 05:17:06PM +0200, Mason wrote: > On 04/08/2015 15:41, Mason wrote: > > > I have a few very naive questions about [snip] > > [META] > > Are there perhaps more suitable mailing lists than this one > for such beginner questions? I thought your message yesterday indicated you'd found the answer. You don't setup any kind of routing between CPU cores and devices. At boot, initially CPU 0 will "own" all interrupts. You then run a (fixed) version of irqbalanced (preferably the older version which is not so x86-centric, eg, 0.56) which then distributes the interrupts between the cores according to what the interrupt is used for and the load it is imposing on the system. -- FTTC broadband for 0.8mile line: currently at 10.5Mbps down 400kbps up according to speedtest.net.