From: marex@denx.de (Marek Vasut) Date: Wed, 26 Aug 2015 16:39:02 +0200 Subject: [PATCH linux-next v5 3/5] mtd: spi-nor: allow to tune the number of dummy cycles In-Reply-To: <4324f398c0e69e3057e7da6a1a3e0328b44f224f.1440580764.git.cyrille.pitchen@atmel.com> References: <4324f398c0e69e3057e7da6a1a3e0328b44f224f.1440580764.git.cyrille.pitchen@atmel.com> Message-ID: <201508261639.02377.marex@denx.de> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Wednesday, August 26, 2015 at 02:30:25 PM, Cyrille Pitchen wrote: > The number of dummy cycles used during Fast Read commands can be reduced > to improve transfer performances. Each manufacturer has a dedicated set of > registers to provide the memory with the exact number of dummy cycles it > should expect. Both the memory and the (Q)SPI controller must agree on > this number of dummy cycles. > > The number of dummy cycles can be found into the memory datasheet and > mostly depends on the SPI clock frequency, the Fast Read op code and the > Single/Dual Data Rate mode. > > Probing JEDEC Serial Flash Discoverable Parameters (SFDP) tables would > only provide the driver with a high enough number of dummy cycles for each > Fast Read command to be used for all clock frequencies: this solution > would not be optimized. > > Signed-off-by: Cyrille Pitchen Acked-by: Marek Vasut Best regards, Marek Vasut