From: horms@verge.net.au (Simon Horman) Date: Fri, 13 Nov 2015 10:11:23 +0900 Subject: [PATCH v2 3/3] ARM: shmobile: gose: Add QSPI device to DT In-Reply-To: <56447D49.6060907@cogentembedded.com> References: <1447291763-27527-1-git-send-email-horms+renesas@verge.net.au> <1447291763-27527-4-git-send-email-horms+renesas@verge.net.au> <56447D49.6060907@cogentembedded.com> Message-ID: <20151113011123.GI20462@verge.net.au> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Thu, Nov 12, 2015 at 02:51:37PM +0300, Sergei Shtylyov wrote: > On 11/12/2015 4:29 AM, Simon Horman wrote: > > >Enable the QSPI controller in the gose device tree. > > > >Based similar work for the silk board by by Vladimir Barinov and > >Sergei Shtylyov. > > > >Cc: Vladimir Barinov > >Cc: Sergei Shtylyov > >Signed-off-by: Simon Horman > > > >--- > >Tested: Read /dev/mtd0 with 512K blocks at 1.7MB/s > > > >v2 > >* Move partitions into partitions subnode > > as suggested by Geert Uytterhoeven. > >--- > > arch/arm/boot/dts/r8a7793-gose.dts | 43 ++++++++++++++++++++++++++++++++++++++ > > 1 file changed, 43 insertions(+) > > > >diff --git a/arch/arm/boot/dts/r8a7793-gose.dts b/arch/arm/boot/dts/r8a7793-gose.dts > >index 1575ef759047..79be514d3a1c 100644 > >--- a/arch/arm/boot/dts/r8a7793-gose.dts > >+++ b/arch/arm/boot/dts/r8a7793-gose.dts > [...] > >@@ -92,3 +97,41 @@ > > > > status = "okay"; > > }; > >+ > >+&qspi { > >+ pinctrl-0 = <&qspi_pins>; > >+ pinctrl-names = "default"; > >+ > >+ status = "okay"; > >+ > >+ flash at 0 { > >+ compatible = "spansion,s25fl512s", "jedec,spi-nor"; > >+ reg = <0>; > >+ spi-max-frequency = <30000000>; > >+ spi-tx-bus-width = <4>; > >+ spi-rx-bus-width = <4>; > >+ spi-cpol; > >+ spi-cpha; > >+ m25p,fast-read; > >+ > >+ partitions{ > > Need space before {. Thanks, I have corrected that and queued this up for v4.5.