From: horms@verge.net.au (Simon Horman) Date: Tue, 1 Dec 2015 15:41:50 +0900 Subject: [PATCH] ARM: shmobile: alt: Add QSPI device to DT In-Reply-To: References: <1448863990-16276-1-git-send-email-horms+renesas@verge.net.au> Message-ID: <20151201064149.GH16260@verge.net.au> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Mon, Nov 30, 2015 at 09:34:10AM +0100, Geert Uytterhoeven wrote: > On Mon, Nov 30, 2015 at 7:13 AM, Simon Horman > wrote: > > Enable the QSPI controller in the alt device tree. > > > > Based similar work for the silk board by by Vladimir Barinov and > > Sergei Shtylyov. > > > > Cc: Vladimir Barinov > > Cc: Sergei Shtylyov > > Signed-off-by: Simon Horman > > Verified against Alt schematics and r8a7794 datasheet. > > Acked-by: Geert Uytterhoeven > > I can't verify the FLASH layout. Note that p.11 of > ALT_MiniMonitor_Manual(SPI_Boot)_Rev0.01_e.pdf shows a different > FLASH layout for the second and third partition. Thanks. I see the following in v1.9.6 of the BSP[1]. Is it the same as the document you referred to above? partition at 0 { label = "loader"; reg = <0x00000000 0x00080000>; read-only; }; partition at 40000 { label = "user"; reg = <0x00080000 0x00580000>; read-only; }; partition at 440000 { label = "flash"; reg = <0x00600000 0x03a00000>; }; [1] https://git.kernel.org/cgit/linux/kernel/git/horms/renesas-backport.git/tree/arch/arm/boot/dts/r8a7794-alt.dts?h=rcar-gen2/v1.9.6&id=e1acbe074f36d96e901bf5346c50ee51da2ced42#n379