From: linux@arm.linux.org.uk (Russell King - ARM Linux) Date: Thu, 24 Dec 2015 11:01:09 +0000 Subject: [PATCH 05/12] tty: amba-pl011: add register lookup table In-Reply-To: <20151224065437.GA18445@robwan01-pc.asiapac.arm.com> References: <20151116173935.GQ8644@n2100.arm.linux.org.uk> <20151224065437.GA18445@robwan01-pc.asiapac.arm.com> Message-ID: <20151224110108.GD8644@n2100.arm.linux.org.uk> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Thu, Dec 24, 2015 at 06:54:40AM +0000, Huang Shijie wrote: > On Mon, Nov 16, 2015 at 05:40:26PM +0000, Russell King wrote: > Hi Russell, > > > Add a register lookup table, which allows the register offsets to be > > adjusted on a per-port basis. > I met a console hang with my ARM juno-r1 board after the linux-next merge this patch. > > The console hang like this: > > ================================== > on will start in 1 seconds > EFI stub: Booting Linux Kernel... > EFI stub: Using DTB from command line > EFI stub: Exiting boot services and installing virtual address map... > ================================== > > The console runs well if I revert this patch. Does anyone also meet the > same hang issue? I'd guess that this is some kind of conflict between EFI patches and this patch set - this patch is a no-op in itself when applied to the version it was developed against. -- RMK's Patch system: http://www.arm.linux.org.uk/developer/patches/ FTTC broadband for 0.8mile line: currently at 9.6Mbps down 400kbps up according to speedtest.net.