From: Chris Packham Date: Thu, 18 Jan 2018 17:16:06 +1300 Subject: [U-Boot] [PATCH v2 0/4] ddr: marvell: update DDR driver Message-ID: <20180118041610.20669-1-judge.packham@gmail.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de I have a custom board that sees correctable ECC errors (when running memtester[1] from Linux). When I used Marvell's bootloader I didn't see the errors. I've also had a tame hardware engineer (if there is such a thing) looking at the timing waveforms comparing the stock u-boot behaviour against Marvell's bootloader. The changes for this series have been derived by comparing scope captures and register output between the same system running stock u-boot and Marvell's USP. Changes in v2: - Update tODT_OFF_WR as well - Added patches 2-4 Chris Packham (4): ddr: marvell: only assert M_ODT[0] on write for a single CS ddr: marvell: use correct TREFI value ddr: marvell: update additional ODT setting ddr: marvell: update ddr controller init and freq drivers/ddr/marvell/a38x/ddr3_init.h | 3 +- drivers/ddr/marvell/a38x/ddr3_topology_def.h | 3 +- drivers/ddr/marvell/a38x/ddr3_training.c | 50 +++++++++++++++--------- drivers/ddr/marvell/a38x/ddr3_training_db.c | 19 +++++---- drivers/ddr/marvell/a38x/ddr3_training_hw_algo.c | 22 +++++++---- drivers/ddr/marvell/a38x/ddr3_training_static.c | 3 +- 6 files changed, 62 insertions(+), 38 deletions(-) -- 2.15.1