From: andrew@lunn.ch (Andrew Lunn) Date: Fri, 2 Mar 2018 23:04:45 +0100 Subject: [PATCH 2/2] ARM: dts: armada388-clearfog: add SFP module support In-Reply-To: <20180302220215.GC9418@n2100.armlinux.org.uk> References: <20180227160135.GU9418@n2100.armlinux.org.uk> <20180302215614.GD25189@lunn.ch> <20180302220215.GC9418@n2100.armlinux.org.uk> Message-ID: <20180302220445.GF25189@lunn.ch> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Fri, Mar 02, 2018 at 10:02:15PM +0000, Russell King - ARM Linux wrote: > On Fri, Mar 02, 2018 at 10:56:14PM +0100, Andrew Lunn wrote: > > On Tue, Feb 27, 2018 at 04:02:02PM +0000, Russell King wrote: > > > Add SFP module support for Clearfog using the SFP phylink support. > > > > > > Signed-off-by: Russell King > > > > Tested-by: Andrew Lunn > > > > Using a RoboFiber SFP module, connected to a media converter. Link > > up/down detected. > > ethtool -m should also work. Yes, it does. Sorry, should of said that. root at clearfog:~# ethtool -m eth1 Identifier : 0x03 (SFP) Extended identifier : 0x04 (GBIC/SFP defined by 2-wire interface ID) Connector : 0x07 (LC) Transceiver codes : 0x00 0x00 0x00 0x01 0x00 0x00 0x00 0x00 Transceiver type : Ethernet: 1000BASE-SX Encoding : 0x01 (8B/10B) BR, Nominal : 1300MBd Rate identifier : 0x00 (unspecified) Length (SMF,km) : 0km Length (SMF) : 0m Length (50um) : 550m Length (62.5um) : 270m Length (Copper) : 0m Length (OM3) : 0m Laser wavelength : 850nm Vendor name : OEM Vendor OUI : 20:20:20 Vendor PN : SFP-7000-85 Vendor rev : 11.0 Optical diagnostics support : Yes Laser bias current : 45.512 mA Laser output power : 0.2861 mW / -5.43 dBm Receiver signal average optical power : 0.2749 mW / -5.61 dBm Module temperature : 25.72 degrees C / 78.29 degrees F Module voltage : 3.2856 V ... Andrew