From: Tom Rini Date: Tue, 11 Sep 2018 08:25:49 -0400 Subject: [U-Boot] [U-Boot,V4,2/2] mmc: fsl_esdhc: enable HS400 feature In-Reply-To: <20180810060755.25287-2-peng.fan@nxp.com> References: <20180810060755.25287-2-peng.fan@nxp.com> Message-ID: <20180911122549.GK4980@bill-the-cat> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On Fri, Aug 10, 2018 at 02:07:55PM +0800, Peng Fan wrote: > The strobe dll code is ported from Linux Kernel: > drivers/mmc/host/sdhci-esdhc-imx.c > The comments are from the above file, > "For HS400 eMMC, there is a data_strobe line. This signal is generated > by the device and used for data output and CRC status response output > in HS400 mode. The frequency of this signal follows the frequency of > CLK generated by host. The host receives the data which is aligned to the > edge of data_strobe line. Due to the time delay between CLK line and > data_strobe line, if the delay time is larger than one clock cycle, > then CLK and data_strobe line will be misaligned, read error shows up. > So when the CLK is higher than 100MHz, each clock cycle is short enough, > host should configure the delay target. " > > Signed-off-by: Peng Fan > Cc: Jaehoon Chung > Cc: Stefano Babic Applied to u-boot/master, thanks! -- Tom -------------- next part -------------- A non-text attachment was scrubbed... Name: signature.asc Type: application/pgp-signature Size: 819 bytes Desc: not available URL: