From: Maxime Ripard Date: Tue, 8 Jan 2019 11:17:15 +0100 Subject: [U-Boot] [PATCH 1/1] sunxi: board: Add i2c initialization for sun50i In-Reply-To: <20190108100430.16647-1-stefan@olimex.com> References: <20190108100430.16647-1-stefan@olimex.com> Message-ID: <20190108101715.kvbfcnfjj5mnvx5w@flea> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On Tue, Jan 08, 2019 at 12:04:30PM +0200, Stefan Mavrodiev wrote: > To use TWI0/1/2 the user can select CONFIG_I2C#_ENABLE. > However even the controller is enabled, the mux for the pins > are not set. > > This patch follows the existing mux method. Since the pads are > different, separate check is added for each i2c. > > Tested with A64-SOM204 board. > > Signed-off-by: Stefan Mavrodiev Acked-by: Maxime Ripard Thanks! Maxime -- Maxime Ripard, Bootlin Embedded Linux and Kernel engineering https://bootlin.com -------------- next part -------------- A non-text attachment was scrubbed... Name: signature.asc Type: application/pgp-signature Size: 228 bytes Desc: not available URL: