From: Janosch Frank Date: Thu, 10 Jan 2019 15:41:44 +0000 Subject: [kvm-unit-tests PATCH v5 04/11] s390x: Switch to z/Arch and enable 64 bit addressing mode Message-Id: <20190110154151.24233-5-frankja@linux.ibm.com> To: linux-s390@vger.kernel.org, kvm@vger.kernel.org List-ID: LPAR and z/VM start in esam mode depending on the hardware (CZAM facility and others affect this), so we need to switch to z/Arch and set 64 bit addressing. Under Qemu/KVM we already start out with both when being run with the Qemu --kernel argument or we lack 64 bit when booting from disk because of the initial psw specifying 31 bit for z/VM and lpar compatibility. Signed-off-by: Janosch Frank Reviewed-by: David Hildenbrand Reviewed-by: Thomas Huth --- s390x/cstart64.S | 11 +++++++++++ 1 file changed, 11 insertions(+) diff --git a/s390x/cstart64.S b/s390x/cstart64.S index 385915e..6622633 100644 --- a/s390x/cstart64.S +++ b/s390x/cstart64.S @@ -11,6 +11,7 @@ * under the terms of the GNU Library General Public License version 2. */ #include +#include .section .init @@ -20,9 +21,19 @@ * * For KVM and TCG kernel boot we are in 64 bit z/Arch mode. * When booting from disk the initial short psw is in 31 bit mode. + * When running under LPAR or z/VM, we might start in 31 bit and esam mode. */ .globl start start: + /* Switch to z/Architecture mode and 64-bit */ + slr %r0, %r0 # Set cpuid to zero + lhi %r1, 2 # mode 2 = esame + sigp %r1, %r0, SIGP_SET_ARCHITECTURE + /* XOR all registers with themselves to clear them fully. */ + .irp i, 0,1,2,3,4,5,6,7,8,9,10,11,12,13,14,15 + xgr \i,\i + .endr + sam64 # Set addressing mode to 64 bit /* setup stack */ larl %r15, stackptr /* setup initial PSW mask + control registers*/ -- 2.14.3