From: Gregory CLEMENT Date: Wed, 16 Jan 2019 14:07:39 +0100 Subject: [U-Boot] [PATCH v2 0/4] Add network support for Ocelots SoCs Message-ID: <20190116130743.20539-1-gregory.clement@bootlin.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Hello, this the second version of a series allowing to use the switch component of the Ocelots SoC as a network interface. The binding used is exactly the same of the one already used by Linux. There is also a patch adding a workaround needed on the Ocelot based boards: indeed the pin connected to the DDR reset is part of the switch subsystem. So we need ensure that the DDR is not reset during the switch reset. Gregory Changelog: v1 -> v2: - Use wait_for_bit_le32() (suggested by Stefan Roese) - Use debug() instead of printf() for the debug messages in mscc_switch_reset. Gregory CLEMENT (4): MIPS: mscc: ocelot: Add ethernet nodes for Ocelot net: add MSCC Ocelot switch support MIPS: mscc: ocelot: add switch reset support configs: mscc_ocelot: add network support MAINTAINERS | 1 + arch/mips/dts/mscc,ocelot.dtsi | 97 ++++ arch/mips/dts/ocelot_pcb123.dts | 20 + board/mscc/ocelot/ocelot.c | 26 + configs/mscc_ocelot_defconfig | 1 + drivers/net/Kconfig | 7 + drivers/net/Makefile | 1 + drivers/net/ocelot_switch.c | 837 ++++++++++++++++++++++++++++++++ 8 files changed, 990 insertions(+) create mode 100644 drivers/net/ocelot_switch.c -- 2.20.1