From: Simon Glass Date: Tue, 29 Jan 2019 20:59:29 -0700 Subject: [U-Boot] [PATCH 34/40] x86: Add documention on the samus flashmap In-Reply-To: <20190130035935.235565-1-sjg@chromium.org> References: <20190130035935.235565-1-sjg@chromium.org> Message-ID: <20190130035935.235565-35-sjg@chromium.org> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de There are quite a few variables which control where things appear in the final ROM image. Add a flashmap in the documentation to make this easier to figure out. Signed-off-by: Simon Glass --- doc/README.x86 | 14 ++++++++++++++ 1 file changed, 14 insertions(+) diff --git a/doc/README.x86 b/doc/README.x86 index fa49cb8b8a..d5224b7536 100644 --- a/doc/README.x86 +++ b/doc/README.x86 @@ -185,6 +185,20 @@ If you are using em100, then this command will flash write -Boot: em100 -s -d filename.rom -c W25Q64CV -r +Flash map for samus / broadwell: + + fffff800 SYS_X86_START16 + ffff0000 RESET_SEG_START + fffd8000 TPL_TEXT_BASE + fffa0000 X86_MRC_ADDR + fff90000 VGA_BIOS_ADDR + ffed0000 SYS_TEXT_BASE + ffea0000 X86_REFCODE_ADDR + ffe70000 SPL_TEXT_BASE + ffa00000 + ff801000 intel-me (address set by descriptor.bin) + ff800000 intel-descriptor + --- Intel Crown Bay specific instructions for bare mode: -- 2.20.1.495.gaa96b0ce6b-goog