From: Jonathan Gray Date: Thu, 31 Jan 2019 08:38:38 +1100 Subject: [U-Boot] [PATCH] rpi: add Compute Module 3+ In-Reply-To: <88097da9-a6b1-055c-cc91-eea151ea9c44@suse.de> References: <20190130141724.22574-1-jsg@jsg.id.au> <88097da9-a6b1-055c-cc91-eea151ea9c44@suse.de> Message-ID: <20190130213838.GA7178@largo.jsg.id.au> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On Wed, Jan 30, 2019 at 04:13:44PM +0100, Alexander Graf wrote: > Hi Jonathan, > > On 30.01.19 15:17, Jonathan Gray wrote: > > Add Raspberry Pi Compute Module 3+ to list of models, the revision code > > is 0x10 according to the list on raspberrypi.org. > > > > Signed-off-by: Jonathan Gray > > --- > > board/raspberrypi/rpi/rpi.c | 5 +++++ > > 1 file changed, 5 insertions(+) > > > > diff --git a/board/raspberrypi/rpi/rpi.c b/board/raspberrypi/rpi/rpi.c > > index 153a1fdcb7..c118250740 100644 > > --- a/board/raspberrypi/rpi/rpi.c > > +++ b/board/raspberrypi/rpi/rpi.c > > @@ -143,6 +143,11 @@ static const struct rpi_model rpi_models_new_scheme[] = { > > DTB_DIR "bcm2837-rpi-3-a-plus.dtb", > > false, > > }, > > + [0x10] = { > > + "Compute Module 3+", > > + DTB_DIR "bcm2837-rpi-cm3-plus.dtb", > > Is the dtb name already committed to? I haven't seen patches on the rpi > kernel ML. I didn't see an existing name in various linux trees. There is currently no new dtb provided with the firmware either, though https://raw.githubusercontent.com/raspberrypi/documentation/master/hardware/computemodule/datasheets/rpi_DATA_CM3plus_1p0.pdf states "CM3+ modules require a software/firmware image dated November 2018 or newer to function correctly." So the firmware likely patches bcm2710-rpi-cm3.dtb before passing it on.