From: sbabic at denx.de Date: Sat, 16 Feb 2019 10:26:42 +0000 (UTC) Subject: [U-Boot] ARM: imx6q_logic: Enable SPL Booting from NAND In-Reply-To: <20190112232452.18624-1-aford173@gmail.com> Message-ID: <20190216102824.4E004C21F03@lists.denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de > This patch fixes a few values that were incorrect, and this > now lets SPL boot from NAND. > Signed-off-by: Adam Ford > diff --git a/configs/imx6q_logic_defconfig b/configs/imx6q_logic_defconfig > index 457366a664..f56f532631 100644 > --- a/configs/imx6q_logic_defconfig > +++ b/configs/imx6q_logic_defconfig > @@ -16,6 +16,7 @@ CONFIG_BOOTDELAY=3 > # CONFIG_USE_BOOTCOMMAND is not set > CONFIG_SYS_CONSOLE_IS_IN_ENV=y > CONFIG_SYS_CONSOLE_OVERWRITE_ROUTINE=y > +CONFIG_SPL_RAW_IMAGE_SUPPORT=y > CONFIG_SPL_SEPARATE_BSS=y > # CONFIG_TPL_BANNER_PRINT is not set > # CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_SECTOR is not set > @@ -30,7 +31,8 @@ CONFIG_SPL_USB_SDP_SUPPORT=y > CONFIG_SPL_WATCHDOG_SUPPORT=y > CONFIG_SYS_PROMPT="i.MX6 Logic # " > CONFIG_CMD_SPL=y > -CONFIG_CMD_SPL_WRITE_SIZE=0x20000 > +CONFIG_CMD_SPL_NAND_OFS=0x1500000 > +CONFIG_CMD_SPL_WRITE_SIZE=0x00100000 > CONFIG_CMD_MEMTEST=y > # CONFIG_CMD_FLASH is not set > CONFIG_CMD_GPIO=y > diff --git a/include/configs/imx6_logic.h b/include/configs/imx6_logic.h > index e55941408c..70cc63fc1b 100644 > --- a/include/configs/imx6_logic.h > +++ b/include/configs/imx6_logic.h > @@ -144,6 +144,8 @@ > #define CONFIG_SYS_NAND_U_BOOT_START CONFIG_SYS_TEXT_BASE > #define CONFIG_SYS_NAND_U_BOOT_OFFS 0x200000 > #define CONFIG_SYS_NAND_SPL_KERNEL_OFFS 0x00500000 > +#define CONFIG_SYS_NAND_USE_FLASH_BBT > + > /* MTD device */ > > /* DMA stuff, needed for GPMI/MXS NAND support */ > @@ -162,7 +164,7 @@ > /* Falcon Mode */ > #define CONFIG_SPL_FS_LOAD_ARGS_NAME "args" > #define CONFIG_SPL_FS_LOAD_KERNEL_NAME "uImage" > -#define CONFIG_SYS_SPL_ARGS_ADDR 0x15000000 > +#define CONFIG_SYS_SPL_ARGS_ADDR 0x18000000 > > /* Falcon Mode - MMC support: args at 1MB kernel at 2MB */ > #define CONFIG_SYS_MMCSD_RAW_MODE_ARGS_SECTOR 0x800 /* 1MB */ Applied to u-boot-imx, master, thanks ! Best regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, Managing Director: Wolfgang Denk HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de =====================================================================