From: Krzysztof Kozlowski Subject: [PATCH 3/3] ARM: dts: exynos: Extend the eMMC node on Arndale Octa Date: Sat, 9 Mar 2019 16:00:39 +0100 Message-ID: <20190309150039.8705-3-krzk@kernel.org> References: <20190309150039.8705-1-krzk@kernel.org> Return-path: In-Reply-To: <20190309150039.8705-1-krzk@kernel.org> Sender: linux-kernel-owner@vger.kernel.org To: Kukjin Kim , Krzysztof Kozlowski , devicetree@vger.kernel.org, linux-arm-kernel@lists.infradead.org, linux-samsung-soc@vger.kernel.org, linux-kernel@vger.kernel.org Cc: Marek Szyprowski List-Id: devicetree@vger.kernel.org Describe properly the MMC0 node (with attached embedded MMC memory) on Arndale Node by: 1. Adding the regulator for host interface (although it still has to be "always-on" so the board with Linaro U-Boot will boot; 2. Using "non-removable" instead of "broken-cd" property, because eMMC is embedded into the board; 3. Adding support for HS200 v1.8 to indicate support in host controller although this has no practical effect (embedded memory does not support it). Signed-off-by: Krzysztof Kozlowski --- arch/arm/boot/dts/exynos5420-arndale-octa.dts | 10 +++++++++- 1 file changed, 9 insertions(+), 1 deletion(-) diff --git a/arch/arm/boot/dts/exynos5420-arndale-octa.dts b/arch/arm/boot/dts/exynos5420-arndale-octa.dts index 96a0eb73a99b..56a42c68bc39 100644 --- a/arch/arm/boot/dts/exynos5420-arndale-octa.dts +++ b/arch/arm/boot/dts/exynos5420-arndale-octa.dts @@ -378,6 +378,12 @@ regulator-name = "PVDD_APIO_MMCON_1V8"; regulator-min-microvolt = <1800000>; regulator-max-microvolt = <1800000>; + /* + * Must be always on, even though there is + * a consumer (mmc_0). Otherwise the board + * does not reboot with vendor U-Boot + * (Linaro for Arndale Octa, v2012.07). + */ regulator-always-on; }; @@ -685,7 +691,7 @@ &mmc_0 { status = "okay"; - broken-cd; + non-removable; card-detect-delay = <200>; samsung,dw-mshc-ciu-div = <3>; samsung,dw-mshc-sdr-timing = <0 4>; @@ -693,8 +699,10 @@ pinctrl-names = "default"; pinctrl-0 = <&sd0_clk &sd0_cmd &sd0_bus1 &sd0_bus4 &sd0_bus8>; vmmc-supply = <&ldo10_reg>; + vqmmc-supply = <&ldo3_reg>; bus-width = <8>; cap-mmc-highspeed; + mmc-hs200-1_8v; }; &mmc_2 { -- 2.17.1