From: sbabic at denx.de Date: Wed, 13 Mar 2019 09:38:01 +0000 (UTC) Subject: [U-Boot] [U-Boot, v1, 18/26] colibri imx6: disable ri and dcd irq in uarts In-Reply-To: <20190208174229.23562-19-marcel@ziswiler.com> Max Krummenacher Message-ID: <20190313100038.90DDCC220BB@lists.denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de > From: Max Krummenacher > If the UART is used in DTE mode the RI and DCD bits in UCR3 become > irq enable bits. Both are set to enabled after reset and both likely > are pending. > Disable the bits also on UARTs not used in the boot loader to prevent > an interrupt storm when Linux enables the UART interrupts. > Signed-off-by: Max Krummenacher > Acked-by: Marcel Ziswiler Applied to u-boot-imx, -next, thanks ! Best regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, Managing Director: Wolfgang Denk HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de =====================================================================