From: Tom Rini Date: Thu, 9 May 2019 10:02:56 -0400 Subject: [U-Boot] U-Boot PXA support In-Reply-To: <20190506132604.GQ31207@bill-the-cat> References: <20190506132604.GQ31207@bill-the-cat> Message-ID: <20190509140256.GD25571@bill-the-cat> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On Mon, May 06, 2019 at 09:26:04AM -0400, Tom Rini wrote: > Hey folks, > > I'm attempting, again, to see what we need to do in order to use gcc-8.x > for U-Boot and ran into, again: > https://patchwork.ozlabs.org/patch/920329/ which in short is that when > using -mcpu=xscale gcc-8.x throws an odd error: > cc1: error: switch -mcpu=xscale conflicts with -march=armv5te switch [-Werror] > > Now note, U-Boot isn't passing -march= at all, just -mcpu=xscale which > suggests perhaps something broke in upstream gcc. Looking at the > kernel, it's not used -mcpu=xscale ever, just -mtune=xscale but that > leads to different failures (seen here with gcc-7.3): > CC drivers/usb/gadget/pxa25x_udc.o > {standard input}: Assembler messages: > {standard input}:779: Error: selected processor does not support `pld [lr]' in ARM mode > {standard input}:1201: Error: selected processor does not support `pld [r7]' in ARM mode > {standard input}:2519: Error: selected processor does not support `pld [r3]' in ARM mode > {standard input}:2796: Error: selected processor does not support `pld [r3]' in ARM mode > > So, what should we do about this? Is there still active interest in > supporting the PXA platforms? Thanks folks! ping? Thanks! -- Tom -------------- next part -------------- A non-text attachment was scrubbed... Name: signature.asc Type: application/pgp-signature Size: 819 bytes Desc: not available URL: