From: Eugeniu Rosca Date: Mon, 20 May 2019 09:39:07 +0200 Subject: [U-Boot] [PATCH 4/4] ARM: renesas: Configure DRAM size from ATF DT fragment In-Reply-To: <7a2d021b-0ef0-c1d2-49cf-33ffaf8c40b7@gmail.com> References: <20190305032557.19788-1-marek.vasut+renesas@gmail.com> <20190305032557.19788-4-marek.vasut+renesas@gmail.com> <6ab7ba1d-df1d-6636-28f7-20817c3d9491@gmail.com> <20190313152554.GA30270@vmlxhi-102.adit-jv.com> <8016a638-be20-1992-7ca0-1ff59448f159@gmail.com> <20190404134554.GA25815@vmlxhi-102.adit-jv.com> <7a2d021b-0ef0-c1d2-49cf-33ffaf8c40b7@gmail.com> Message-ID: <20190520073907.GA4591@vmlxhi-102.adit-jv.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Hi Marek, On Mon, May 20, 2019 at 12:50:07AM +0200, Marek Vasut wrote: > On 4/4/19 3:45 PM, Eugeniu Rosca wrote: [..] > >>> [..] > >>> > >>> Besides the above, I wonder why this patch duplicates code across three > >>> board files? Could this code be relocated to some common area like [1]? > >> > >> That's the plan. > > > > I look forward to seeing v2 then, since this would allow us not > > duplicating this code over and over again in the board-specific files > > of the customer R-Car3 targets. > Should be fixed by > http://patchwork.ozlabs.org/patch/1101744/ Thank you very much. We'll check it out later and report the results (don't feel blocked however). Thanks again! -- Best Regards, Eugeniu.