From: Neil Armstrong Subject: [PATCH 0/5] drm/meson: Add support for HDMI2.0 YUV420 4k60 Date: Mon, 20 May 2019 15:37:48 +0200 Message-ID: <20190520133753.23871-1-narmstrong@baylibre.com> Mime-Version: 1.0 Content-Transfer-Encoding: 8bit Return-path: Sender: linux-kernel-owner@vger.kernel.org To: a.hajda@samsung.com, Laurent.pinchart@ideasonboard.com Cc: jonas@kwiboo.se, hverkuil@xs4all.nl, Neil Armstrong , dri-devel@lists.freedesktop.org, jernej.skrabec@siol.net, heiko@sntech.de, maxime.ripard@bootlin.com, hjc@rock-chips.com, linux-amlogic@lists.infradead.org, linux-kernel@vger.kernel.org List-Id: dri-devel@lists.freedesktop.org The Synopsys DW-HDMI CSC does not support downsampling to YUV420, so the encoder must downsamle before, feeding the controller with a YUV420 pixel stream. The encoder must declare the new bus format enc encoding the bridge, in order to take it in account. To solve this, a new format_set() bridge op is added, permitting setting a new input bus format and encoding to the bridge chain. This solves YUV420 setup, but also solved setting 10bit, 12bit or 16bit input bus format in order to support HDMI >8bit depths. The DW-HDMI controller is updated to dynamically select a coherent output bus format depending on the input bus format and on the internal CSC supported modes. The DW-HDMI is also updated to support the connector display_info bus_formats entry to permit forcing a specific output bus format to force, for example, an YUV444 output format instead of the default RGB output bus format. Only the meson DRM dw_hdmi glue allows ycbcr420 modes, so no breakage is expected here. The remaining patches adds support for 4:2:0 output and clock setup for the meson DW-HDMI glue, and how YUV444 output can be forced. Changes since rfc: * Fixed small logic error in drm_bridge_format_set() * rebased on v5.2-rc1 Neil Armstrong (5): drm/bridge: dw-hdmi: allow ycbcr420 modes for >= 0x200a drm/bridge: add encoder support to specify bridge input format drm/bridge: dw-hdmi: Add support for dynamic output format setup drm/meson: Add YUV420 output support drm/meson: Output in YUV444 if sink supports it drivers/gpu/drm/bridge/synopsys/dw-hdmi.c | 127 ++++++++++++++++++++-- drivers/gpu/drm/drm_bridge.c | 35 ++++++ drivers/gpu/drm/meson/meson_dw_hdmi.c | 111 ++++++++++++++++--- drivers/gpu/drm/meson/meson_vclk.c | 93 ++++++++++++---- drivers/gpu/drm/meson/meson_vclk.h | 7 +- drivers/gpu/drm/meson/meson_venc.c | 6 +- drivers/gpu/drm/meson/meson_venc.h | 11 ++ drivers/gpu/drm/meson/meson_venc_cvbs.c | 3 +- include/drm/bridge/dw_hdmi.h | 1 + include/drm/drm_bridge.h | 19 ++++ 10 files changed, 358 insertions(+), 55 deletions(-) -- 2.21.0