From: Tom Rini Date: Thu, 18 Jul 2019 20:00:56 -0400 Subject: [U-Boot] [PATCH v2 07/12] armV7R: K3: am654: Load SYSFW binary and config from boot media In-Reply-To: <20190604225555.12186-8-dannenberg@ti.com> References: <20190604225555.12186-1-dannenberg@ti.com> <20190604225555.12186-8-dannenberg@ti.com> Message-ID: <20190719000056.GC20116@bill-the-cat> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On Tue, Jun 04, 2019 at 05:55:50PM -0500, Andreas Dannenberg wrote: > Use the System Firmware (SYSFW) loader framework to load and start > the SYSFW as part of the AM654 early initialization sequence. While > at it also initialize the WKUP_UART0 pinmux as it is used by SYSFW > to print diagnostic messages. > > Signed-off-by: Andreas Dannenberg Applied to u-boot/master, thanks! -- Tom -------------- next part -------------- A non-text attachment was scrubbed... Name: signature.asc Type: application/pgp-signature Size: 819 bytes Desc: not available URL: