From: sbabic at denx.de Date: Sat, 20 Jul 2019 08:57:19 +0000 (UTC) Subject: [U-Boot] [PATCH 5/5] mx7ulp_evk: Update DDR freq to 352.8Mhz for ULP B0 Message-ID: <20190720091255.CCCFBC21E4E@lists.denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de > From: Ye Li > On i.MX7ULP B0, the DDR clock target is increased from 320Mhz to 380Mhz. > We update DDR clock relevant settings to approach the target. But since the > limitation on LCDIF pix clock for HDMI output > (refer "mx7ulp_evk: Change APLL and its PFD0 frequencies"), we set DDR > clock to 352.8Mhz (25.2Mhz * 14) by using the clock path: > APLL PFD0 -> DDR CLK -> NIC0 -> NIC1 -> LCDIF clock > To reduce the impact to entire system, the NIC0_DIV and NIC1_DIV are kept, > so the divider 14 is calculated as: > 14 = (NIC0_DIV + 1) * (NIC1_DIV + 1) * (LCDIF_PCC_DIV + 1) > NIC0_DIV: 1 > NIC1_DIV: 0 > LCDIF_PCC_DIV: 6 > APLL and APLL PFD0 settings: > PFD0 FRAC: 27 > APLL MULT: 22 > APLL NUM: 1 > APLL DENOM: 20 > This patch applies the new settings for both DCD and plugin. > There is no DDR script change on this new frequency. > Overnight memtester is passed. > Signed-off-by: Ye Li > Reviewed-by: Peng Fan Applied to u-boot-imx, master, thanks ! Best regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, Managing Director: Wolfgang Denk HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de =====================================================================