From: Tom Rini Date: Sun, 28 Jul 2019 17:49:12 -0400 Subject: [U-Boot] [PATCH 1/4] ARM: dts: dra7-mmc-iodelay: Add a new pinctrl group for clk line without pullup In-Reply-To: <20190620093722.15471-2-faiz_abbas@ti.com> References: <20190620093722.15471-1-faiz_abbas@ti.com> <20190620093722.15471-2-faiz_abbas@ti.com> Message-ID: <20190728214912.GK20116@bill-the-cat> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On Thu, Jun 20, 2019 at 03:07:19PM +0530, Faiz Abbas wrote: > During a short period when the bus voltage is switched from 3.3v to 1.8v, > (to enumerate UHS mode), the mmc module is disabled and the mmc IO lines > are kept in a state according to the programmed pad mux pull type. > > According to 4.2.4.2 Timing to Switch Signal Voltage in "SD Specifications > Part 1 Physical Layer Specification Version 5.00 February 22, 2016", the > host should hold CLK low for at least 5ms. > > In order to keep the card line low during voltage switch, the pad mux of > mmc1_clk line should be configured to pull down. > > Add a new pinctrl group for clock line without pullup to be used in boards > where mmc1_clk line is not connected to an external pullup. > > Signed-off-by: Faiz Abbas Applied to u-boot/master, thanks! -- Tom -------------- next part -------------- A non-text attachment was scrubbed... Name: signature.asc Type: application/pgp-signature Size: 819 bytes Desc: not available URL: