From: Tom Rini Date: Sun, 28 Jul 2019 17:49:31 -0400 Subject: [U-Boot] [PATCH 3/4] ARM: dts: am57xx: Disable voltage switching for SD card In-Reply-To: <20190620093722.15471-4-faiz_abbas@ti.com> References: <20190620093722.15471-1-faiz_abbas@ti.com> <20190620093722.15471-4-faiz_abbas@ti.com> Message-ID: <20190728214931.GM20116@bill-the-cat> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On Thu, Jun 20, 2019 at 03:07:21PM +0530, Faiz Abbas wrote: > If UHS speed modes are enabled, a compatible SD card switches down to 1.8V > during enumeration. If after this a software reboot/crash takes place and > on-chip ROM tries to enumerate the SD card, the difference in > IO voltages (host @ 3.3V and card @ 1.8V) may end up damaging the card. > > The fix for this is to have support for power cycling the card in > hardware (with a PORz/soft-reset line causing a power cycle of the card). > Because the beaglebone X15 (rev A,B and C), am57xx-evms and am57xx-idks don't > have this capability, disable voltage switching for these boards. > > The major effect of this is that the maximum supported speed mode is now > high speed(50 MHz) down from SDR104(200 MHz). > > Signed-off-by: Faiz Abbas Applied to u-boot/master, thanks! -- Tom -------------- next part -------------- A non-text attachment was scrubbed... Name: signature.asc Type: application/pgp-signature Size: 819 bytes Desc: not available URL: