From: Igor Opaniuk Date: Wed, 31 Jul 2019 15:04:37 +0300 Subject: [U-Boot] [PATCH v1 1/9] apalis-tk1: do not explicitly release reset_moci# In-Reply-To: <20190731120445.2459-1-igor.opaniuk@gmail.com> References: <20190731120445.2459-1-igor.opaniuk@gmail.com> Message-ID: <20190731120445.2459-2-igor.opaniuk@gmail.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de From: Marcel Ziswiler By keeping RESET_MOCI_CTRL low we avoid explicitly releasing RESET_MOCI#. Please note that module hardware versions up to V1.1A will already release RESET_MOCI# in hardware coming out of reset. Please further note that with this change the USB hub on the Apalis Evaluation board is kept in reset in U-Boot and therefore none of its ports are operational in U-Boot. Signed-off-by: Marcel Ziswiler Signed-off-by: Igor Opaniuk --- board/toradex/apalis-tk1/pinmux-config-apalis-tk1.h | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) diff --git a/board/toradex/apalis-tk1/pinmux-config-apalis-tk1.h b/board/toradex/apalis-tk1/pinmux-config-apalis-tk1.h index 1584d9b2d3..d2d24c4391 100644 --- a/board/toradex/apalis-tk1/pinmux-config-apalis-tk1.h +++ b/board/toradex/apalis-tk1/pinmux-config-apalis-tk1.h @@ -39,7 +39,7 @@ static const struct tegra_gpio_config apalis_tk1_gpio_inits[] = { GPIO_INIT(R, 1, OUT0), /* Shift_CTRL_Dir_In[1] */ GPIO_INIT(R, 2, OUT0), /* Shift_CTRL_OE[3] */ GPIO_INIT(S, 3, OUT0), /* Shift_CTRL_Dir_In[2] */ - GPIO_INIT(U, 4, OUT1), + GPIO_INIT(U, 4, OUT0), /* RESET_MOCI_CTRL */ GPIO_INIT(W, 3, IN), GPIO_INIT(W, 5, IN), GPIO_INIT(BB, 0, IN), -- 2.17.1