From: Shawn Guo Subject: Re: [PATCH 1/2] bus: imx-weim: optionally enable burst clock mode Date: Sat, 3 Aug 2019 10:19:25 +0200 Message-ID: <20190803081924.GE8870@X250.getinternet.no> References: <20190712204316.16783-1-TheSven73@gmail.com> Mime-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit Return-path: Content-Disposition: inline In-Reply-To: <20190712204316.16783-1-TheSven73@gmail.com> List-Unsubscribe: , List-Archive: List-Post: List-Help: List-Subscribe: , Sender: "linux-arm-kernel" Errors-To: linux-arm-kernel-bounces+linux-arm-kernel=m.gmane.org@lists.infradead.org To: Sven Van Asbroeck Cc: Mark Rutland , devicetree@vger.kernel.org, Kees Cook , Arnd Bergmann , Sascha Hauer , linux-kernel@vger.kernel.org, Rob Herring , NXP Linux Team , Pengutronix Kernel Team , Fabio Estevam , linux-arm-kernel@lists.infradead.org List-Id: devicetree@vger.kernel.org On Fri, Jul 12, 2019 at 04:43:15PM -0400, Sven Van Asbroeck wrote: > To enable burst clock mode, add the fsl,burst-clk-enable > property to the weim bus's devicetree node. > > Example: > weim: weim@21b8000 { > compatible = "fsl,imx6q-weim"; > reg = <0x021b8000 0x4000>; > clocks = <&clks 196>; > #address-cells = <2>; > #size-cells = <1>; > ranges = <0 0 0x08000000 0x08000000>; > fsl,weim-cs-gpr = <&gpr>; > fsl,burst-clk-enable; > > client-device@0,0 { > compatible = "something"; > reg = <0 0 0x02000000>; > #address-cells = <1>; > #size-cells = <1>; > bank-width = <2>; > fsl,weim-cs-timing = <0x00620081 0x00000001 0x1c022000 > 0x0000c000 0x1404a38e 0x00000000>; > }; > }; > > Signed-off-by: Sven Van Asbroeck Applied both, thanks.