From: Sasha Levin Subject: [PATCH AUTOSEL 5.2 09/94] arm64: dts: meson-g12a: add missing dwc2 phy-names Date: Wed, 4 Sep 2019 11:56:14 -0400 Message-ID: <20190904155739.2816-9-sashal@kernel.org> References: <20190904155739.2816-1-sashal@kernel.org> Mime-Version: 1.0 Content-Transfer-Encoding: 8bit Return-path: In-Reply-To: <20190904155739.2816-1-sashal@kernel.org> Sender: linux-kernel-owner@vger.kernel.org To: linux-kernel@vger.kernel.org, stable@vger.kernel.org Cc: Neil Armstrong , Kevin Hilman , Sasha Levin , devicetree@vger.kernel.org, linux-amlogic@lists.infradead.org List-Id: devicetree@vger.kernel.org From: Neil Armstrong [ Upstream commit 3d4bacdc207a7b62941700b374e7199cbb184a43 ] The G12A USB2 OTG capable PHY uses a 8bit large UTMI bus, and the OTG controller gets the PHY but width by probing the associated phy. By default it will use 16bit wide settings if a phy is not specified, in our case we specified the phy, but not the phy-names. The dwc2 bindings specifies that if phys is present, phy-names shall be "usb2-phy". Adding phy-names = "usb2-phy" solves the OTG PHY bus configuration. Fixes: 9baf7d6be730 ("arm64: dts: meson: g12a: Add G12A USB nodes") Signed-off-by: Neil Armstrong Signed-off-by: Kevin Hilman Signed-off-by: Sasha Levin --- arch/arm64/boot/dts/amlogic/meson-g12a.dtsi | 1 + 1 file changed, 1 insertion(+) diff --git a/arch/arm64/boot/dts/amlogic/meson-g12a.dtsi b/arch/arm64/boot/dts/amlogic/meson-g12a.dtsi index 9f72396ba7103..4c92c197aeb8a 100644 --- a/arch/arm64/boot/dts/amlogic/meson-g12a.dtsi +++ b/arch/arm64/boot/dts/amlogic/meson-g12a.dtsi @@ -591,6 +591,7 @@ clocks = <&clkc CLKID_USB1_DDR_BRIDGE>; clock-names = "ddr"; phys = <&usb2_phy1>; + phy-names = "usb2-phy"; dr_mode = "peripheral"; g-rx-fifo-size = <192>; g-np-tx-fifo-size = <128>; -- 2.20.1