From: Claudius Heine Date: Tue, 29 Oct 2019 13:17:56 +0100 Subject: [U-Boot] [PATCH v2 2/3] ARM: imx6: DHCOM i.MX6 PDK: spl: Add eMMC initialization to SPL code In-Reply-To: <20191029121759.3582464-1-ch@denx.de> References: <20191029121759.3582464-1-ch@denx.de> Message-ID: <20191029121759.3582464-2-ch@denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de In order for 'bmode emmc' to work, the eMMC needs to be initialized in the SPL. This change initializes the eMMC as BOOT_DEVICE_MMC1 (index=0). Signed-off-by: Claudius Heine --- board/dhelectronics/dh_imx6/dh_imx6_spl.c | 26 +++++++++++++++++++++++ 1 file changed, 26 insertions(+) diff --git a/board/dhelectronics/dh_imx6/dh_imx6_spl.c b/board/dhelectronics/dh_imx6/dh_imx6_spl.c index 1b7acc8df7..f2c3ac3e28 100644 --- a/board/dhelectronics/dh_imx6/dh_imx6_spl.c +++ b/board/dhelectronics/dh_imx6/dh_imx6_spl.c @@ -476,6 +476,32 @@ static void setup_iomux_uart(void) SETUP_IOMUX_PADS(uart1_pads); } +#ifdef CONFIG_FSL_USDHC +struct fsl_esdhc_cfg usdhc_cfg[1] = { + {USDHC4_BASE_ADDR}, +}; + +int board_mmc_get_env_dev(int devno) +{ + return devno - 1; +} + +int board_mmc_getcd(struct mmc *mmc) +{ + return 1; /* eMMC/uSDHC4 is always present */ +} + +int board_mmc_init(bd_t *bis) +{ + SETUP_IOMUX_PADS(usdhc4_pads); + usdhc_cfg[0].esdhc_base = USDHC4_BASE_ADDR; + usdhc_cfg[0].sdhc_clk = mxc_get_clock(MXC_ESDHC4_CLK); + usdhc_cfg[0].max_bus_width = 8; + + return fsl_esdhc_initialize(bis, &usdhc_cfg[0]); +} +#endif + /* USB */ static iomux_v3_cfg_t const usb_pads[] = { IOMUX_PADS(PAD_GPIO_1__USB_OTG_ID | MUX_PAD_CTRL(NO_PAD_CTRL)), -- 2.21.0