From: sbabic at denx.de Date: Mon, 4 Nov 2019 08:55:00 +0000 (UTC) Subject: [U-Boot] [PATCH] arm: mxs: Increase VDDD voltage to match specification In-Reply-To: <20191015162657.19641-1-marex@denx.de> Message-ID: <20191104090118.A639AC21D83@lists.denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de > According to IMX28CEC rev. 4, 10/2018, Table 15. Recommended Operating > Conditions, page 16, the VDDD should be set to 1.55V when the CPU is > operating at 454MHz. This is the case in U-Boot, hence increase the > VDDD voltage. This fixes instability when performing TFTP transfers. > Increase the brownout threshold to 1.4V. The documentation recommends > 1.45V setting for the brownout, however, this triggers failure during > power block init, so keep the brownout slightly lower. > Signed-off-by: Marek Vasut > Cc: Stefano Babic > Reviewed-by: Fabio Estevam Applied to u-boot-imx, master, thanks ! Best regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, Managing Director: Wolfgang Denk HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de =====================================================================