From: sbabic at denx.de Date: Sun, 29 Dec 2019 11:28:07 +0100 (CET) Subject: [PATCH v6] imx: Add support for i.MX28 based XEA board In-Reply-To: <20191208210656.29597-1-lukma@denx.de> Message-ID: <20191229102807.1D00E817BD@phobos.denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de > This patch introduces support for i.MX28 based XEA board. > This board supports DM/DTS in U-Boot proper as well as DM aware drivers > in SPL (u-boot.sb) by using OF_PLATDATA. > More detailed information regarding usage of it can be found in > ./board/liebherr/xea/README file. > U-Boot SPL 2019.10-rc1-00233-g6aa549f05c (Aug 12 2019 - 09:23:36 +0200) > Trying to boot from MMC1 > MMC0: Command 8 timeout (status 0xf0344020) > mmc_load_image_raw_sector: mmc block read error > U-Boot 2019.10-rc1-00233-g6aa549f05c (Aug 12 2019 - 09:23:36 +0200) > CPU: Freescale i.MX28 rev1.2 at 454 MHz > BOOT: SSP SPI #3, master, 3V3 NOR > Model: Liebherr (LWE) XEA i.MX28 Board > DRAM: 128 MiB > MMC: MXS MMC: 0 > Loading Environment from SPI Flash... SF: Detected n25q128a13 with page size 256 Bytes, erase size 64 KiB, total 16 MiB > OK > In: serial > Out: serial > Err: serial > Net: > Warning: ethernet at 800f0000 (eth0) using random MAC address - ce:e1:9e:46:f3:a2 > eth0: ethernet at 800f0000 > Hit any key to stop autoboot: 0 > Signed-off-by: Lukasz Majewski Applied to u-boot-imx, -next, thanks ! Best regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, Managing Director: Wolfgang Denk HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de =====================================================================