From: sbabic at denx.de Date: Mon, 10 Feb 2020 10:07:12 +0100 (CET) Subject: [PATCH v1 4/5] arm: xea: spl: Add GPIO0_0 setup on spl_board_init In-Reply-To: <20200125080140.1267-5-lukma@denx.de> Message-ID: <20200210090712.B53EA8151B@phobos.denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de > Explicitly configure GPIO0_0 in SPL, which controlls 3V3 voltage > on the XEA board (it also supplies TIVAs). > This code would enable TIVAs power supply early (also when board > uses the falcon boot). > Signed-off-by: Lukasz Majewski Applied to u-boot-imx, master, thanks ! Best regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, Managing Director: Wolfgang Denk HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de =====================================================================