From: sbabic at denx.de Date: Mon, 10 Feb 2020 10:08:08 +0100 (CET) Subject: [U-Boot, 03/13] board: ge: bx50v3, imx53ppd: use DM I2C In-Reply-To: <6629776c2ea27f510339f64a03d62ba2c309405b.1580475104.git.ian.ray@ge.com> Message-ID: <20200210090808.74D6080826@phobos.denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de > From: Robert Beckett > Remove old (pre-DM) i2c setup code. > Enable DM i2c. > Convert common code to use DM rtc. > Convert common code to read VPD from eeprom partition. > Convert the generic i2c PMIC init code to use the new da9063 driver. > mx53ppd only: > Correct RTC compatible in device tree. > Enable MXC DM i2c driver. > Define CONFIG_SYS_MALLOC_F_LEN so that DM is available in pre-reloc. > Make GPIO banks available during preloc, since initialisation is done > in board_early_init_f(). > Add gpio_request() calls to satisfy the DM_GPIO compatibility API. > Remove unused power configuration. > Signed-off-by: Robert Beckett > Signed-off-by: Ian Ray Applied to u-boot-imx, master, thanks ! Best regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, Managing Director: Wolfgang Denk HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de =====================================================================