From: Neil Armstrong Subject: [PATCH 0/9] spi: meson-spicc: add support for AXG and G12A variants Date: Thu, 12 Mar 2020 14:31:22 +0100 Message-ID: <20200312133131.26430-1-narmstrong@baylibre.com> Mime-Version: 1.0 Content-Transfer-Encoding: 8bit Cc: Neil Armstrong , linux-spi@vger.kernel.org, linux-amlogic@lists.infradead.org, linux-arm-kernel@lists.infradead.org, linux-kernel@vger.kernel.org To: broonie@kernel.org Return-path: Sender: linux-kernel-owner@vger.kernel.org List-Id: linux-spi.vger.kernel.org The SPICC controller in Amlogic AXG & G12A is capable of driving the CLK/MOSI/SS signal lines through the idle state which avoid the signals floating in unexpected state, is capable of using linear clock divider to reach a much fine tuned range of clocks, while the old controller only uses a power of two clock divider, result at a more coarse clock range and finally is capable of running at 80M clock. The SPICC controller in Amlogic G12A takes the source clock from a specific clock instead of the bus clock and has a different FIFO size and doesn't handle the RX Half interrupt the same way as GXL & AXG variants. Thus the burst management is simplified and takes in account a variable FIFO size. Now the controller can support frequencies higher than 30MHz, we need the setup the I/O line delays in regard of the SPI clock frequency. Neil Armstrong (7): spi: meson-spicc: remove unused variables spi: meson-spicc: support max 80MHz clock spi: meson-spicc: add min sclk for each compatible spi: meson-spicc: setup IO line delay spi: meson-spicc: adapt burst handling for G12A support dt-bindings: spi: amlogic,meson-gx-spicc: add Amlogic G12A compatible spi: meson-spicc: add support for Amlogic G12A Sunny Luo (2): spi: meson-spicc: enhance output enable feature spi: meson-spicc: add a linear clock divider support .../bindings/spi/amlogic,meson-gx-spicc.yaml | 22 + drivers/spi/Kconfig | 1 + drivers/spi/spi-meson-spicc.c | 496 +++++++++++++----- 3 files changed, 392 insertions(+), 127 deletions(-) -- 2.22.0