From: Jaehoon Chung Date: Fri, 27 Mar 2020 13:07:59 +0900 Subject: [Patch V4 0/3] Support SDMA mode on RPI4 target - 32bit References: Message-ID: <20200327040802.30103-1-jh80.chung@samsung.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de RPI4's SDHCI controller is supported SDMA mode. (Checked on kernel side) But It doesn't use on u-boot side. Then it's too slow about read/write performance. This patchset is supported SDMA mode on RPI4 target(32/64bit). - Tested on RPI4 1GB/2GB/4GB target Read/write time about 8MB file Before - Read : 1.472 seconds - Write : 4.690 seconds After - Read : 0.359 seconds - Write : 0.574 seconds This patch is based on my RFC's patches.RPI4's SDHCI controller is supported SDMA mode. (Checked on kernel side) But It doesn't use on u-boot side. Then it's too slow about read/write performance. This patchset is supported SDMA mode on RPI4 target(32bit). - I didn't test on RPI4 64bit. Read/write time about 8MB file Before - Read : 1.472 seconds - Write : 4.690 seconds After - Read : 0.359 seconds - Write : 0.574 seconds Changelog on V4 - Enable SDMA in rpi4_defconfig for 64bit Changelog on V3 - Rebased on latest u-boot-mmc Changelog on V2 - Keep printf message instead of debug - Add Peng's Reviewed-by tag Jaehoon Chung (3): mmc: sdhci: use phys2bus macro when dma address is accessed mmc: sdhci: not return error when SDMA is not supported configs: rpi_4 : enable SDHCI_SDMA config configs/rpi_4_32b_defconfig | 1 + configs/rpi_4_defconfig | 1 + drivers/mmc/sdhci.c | 13 +++++++------ 3 files changed, 9 insertions(+), 6 deletions(-) -- 2.26.0