From: MarkLee Date: Wed, 27 May 2020 19:25:05 +0800 Subject: [U-boot, 1/2] eth: mtk-eth: enable mt7629 sgmii mode support in mediatek eth driver In-Reply-To: <20200527112506.2919-1-Mark-MC.Lee@mediatek.com> References: <20200527112506.2919-1-Mark-MC.Lee@mediatek.com> Message-ID: <20200527112506.2919-2-Mark-MC.Lee@mediatek.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de The sgmii mode init flow is almost the same for all mediatek SoC, the only difference is the register offset(SGMSYS_GEN2_SPEED) is 0x2028 for old chip(mt7622) but changed to 0x128 for newer chip(mt7629 and the following chips). Signed-off-by: MarkLee --- drivers/net/mtk_eth.h | 5 +++++ 1 file changed, 5 insertions(+) diff --git a/drivers/net/mtk_eth.h b/drivers/net/mtk_eth.h index f2940c9996..3c85eab91a 100644 --- a/drivers/net/mtk_eth.h +++ b/drivers/net/mtk_eth.h @@ -44,7 +44,12 @@ #define SGMSYS_QPHY_PWR_STATE_CTRL 0xe8 #define SGMII_PHYA_PWD BIT(4) +#if defined(CONFIG_TARGET_MT7622) #define SGMSYS_GEN2_SPEED 0x2028 +#else +#define SGMSYS_GEN2_SPEED 0x128 +#endif + #define SGMSYS_SPEED_2500 BIT(2) /* Frame Engine Registers */ -- 2.17.1