Return-Path: From: Sasha Levin Subject: [PATCH AUTOSEL 5.6 19/47] s390/mm: fix set_huge_pte_at() for empty ptes Date: Thu, 28 May 2020 07:55:32 -0400 Message-Id: <20200528115600.1405808-19-sashal@kernel.org> In-Reply-To: <20200528115600.1405808-1-sashal@kernel.org> References: <20200528115600.1405808-1-sashal@kernel.org> MIME-Version: 1.0 Content-Transfer-Encoding: 8bit Sender: linux-kernel-owner@vger.kernel.org List-ID: To: linux-kernel@vger.kernel.org, stable@vger.kernel.org Cc: Gerald Schaefer , Vasily Gorbik , Sasha Levin , linux-s390@vger.kernel.org From: Gerald Schaefer [ Upstream commit ac8372f3b4e41015549b331a4f350224661e7fc6 ] On s390, the layout of normal and large ptes (i.e. pmds/puds) differs. Therefore, set_huge_pte_at() does a conversion from a normal pte to the corresponding large pmd/pud. So, when converting an empty pte, this should result in an empty pmd/pud, which would return true for pmd/pud_none(). However, after conversion we also mark the pmd/pud as large, and therefore present. For empty ptes, this will result in an empty pmd/pud that is also marked as large, and pmd/pud_none() would not return true. There is currently no issue with this behaviour, as set_huge_pte_at() does not seem to be called for empty ptes. It would be valid though, so let's fix this by not marking empty ptes as large in set_huge_pte_at(). This was found by testing a patch from from Anshuman Khandual, which is currently discussed on LKML ("mm/debug: Add more arch page table helper tests"). Signed-off-by: Gerald Schaefer Signed-off-by: Vasily Gorbik Signed-off-by: Sasha Levin --- arch/s390/mm/hugetlbpage.c | 9 ++++++--- 1 file changed, 6 insertions(+), 3 deletions(-) diff --git a/arch/s390/mm/hugetlbpage.c b/arch/s390/mm/hugetlbpage.c index 5674710a4841..7dfae86afa47 100644 --- a/arch/s390/mm/hugetlbpage.c +++ b/arch/s390/mm/hugetlbpage.c @@ -159,10 +159,13 @@ void set_huge_pte_at(struct mm_struct *mm, unsigned long addr, rste &= ~_SEGMENT_ENTRY_NOEXEC; /* Set correct table type for 2G hugepages */ - if ((pte_val(*ptep) & _REGION_ENTRY_TYPE_MASK) == _REGION_ENTRY_TYPE_R3) - rste |= _REGION_ENTRY_TYPE_R3 | _REGION3_ENTRY_LARGE; - else + if ((pte_val(*ptep) & _REGION_ENTRY_TYPE_MASK) == _REGION_ENTRY_TYPE_R3) { + if (likely(pte_present(pte))) + rste |= _REGION3_ENTRY_LARGE; + rste |= _REGION_ENTRY_TYPE_R3; + } else if (likely(pte_present(pte))) rste |= _SEGMENT_ENTRY_LARGE; + clear_huge_pte_skeys(mm, rste); pte_val(*ptep) = rste; } -- 2.25.1