From: Tom Rini Date: Tue, 30 Jun 2020 11:16:25 -0400 Subject: [PATCHv5 3/3] spi: Convert CONFIG_DM_SPI* to CONFIG_$(SPL_TPL_)DM_SPI* In-Reply-To: <20200604151153.3980-4-Zhiqiang.Hou@nxp.com> References: <20200604151153.3980-1-Zhiqiang.Hou@nxp.com> <20200604151153.3980-4-Zhiqiang.Hou@nxp.com> Message-ID: <20200630151625.GH1306@bill-the-cat> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On Thu, Jun 04, 2020 at 11:11:53PM +0800, Zhiqiang Hou wrote: > From: Lukasz Majewski > > This change allows more fine tuning of driver model based SPI support in > SPL and TPL. It is now possible to explicitly enable/disable the DM_SPI > support in SPL and TPL via Kconfig option. > > Before this change it was necessary to use: > /* SPI Flash Configs */ > #if defined(CONFIG_SPL_BUILD) > #undef CONFIG_DM_SPI > #undef CONFIG_DM_SPI_FLASH > #undef CONFIG_SPI_FLASH_MTD > #endif > > in the ./include/configs/.h, which is error prone and shall be > avoided when we strive to switch to Kconfig. > > The goal of this patch: > > Provide distinction for DM_SPI support in both U-Boot proper and SPL (TPL). > Valid use case is when U-Boot proper wants to use DM_SPI, but SPL must > still support non DM driver. > > Another use case is the conversion of non DM/DTS SPI driver to support > DM/DTS. When such driver needs to work in both SPL and U-Boot proper, the > distinction is needed in Kconfig (also if SPL version of the driver > supports OF_PLATDATA). > > In the end of the day one would have to support following use cases (in > single driver file - e.g. mxs_spi.c): > > - U-Boot proper driver supporting DT/DTS > - U-Boot proper driver without DT/DTS support (deprecated) > - SPL driver without DT/DTS support > - SPL (and TPL) driver with DT/DTS (when the SoC has enough resources to > run full blown DT/DTS) > - SPL driver with DT/DTS and SPL_OF_PLATDATA (when one have constrained > environment with no fitImage and OF_LIBFDT support). > > Some boards do require SPI support (with DM) in SPL (TPL) and some only > have DM_SPI{_FLASH} defined to allow compiling SPL. > > This patch converts #ifdef CONFIG_DM_SPI* to #if CONFIG_IS_ENABLED(DM_SPI) > and provides corresponding defines in Kconfig. > > Signed-off-by: Lukasz Majewski > Tested-by: Adam Ford #da850-evm > Signed-off-by: Hou Zhiqiang Applied to u-boot/master, thanks! -- Tom -------------- next part -------------- A non-text attachment was scrubbed... Name: signature.asc Type: application/pgp-signature Size: 659 bytes Desc: not available URL: