From: Thomas Petazzoni Date: Mon, 27 Jul 2020 18:04:31 +0200 Subject: [Buildroot] [PATCH v2 1/3] toolchain/toolchain-buildroot: enable uclibc for riscv64 In-Reply-To: <20200510154347.5711-1-mark@dibsco.co.uk> References: <20200510154347.5711-1-mark@dibsco.co.uk> Message-ID: <20200727180431.32097732@windsurf.home> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: buildroot@busybox.net On Sun, 10 May 2020 16:43:45 +0100 Mark Corbin wrote: > We can enable uclibc for RISC-V 64 bit now that it has been > bumped from v1.0.32 to v1.0.34. > > Uclibc has had basic support for RISC-V 64 bit since v1.0.31, but > shared library and TLS/NPTL support has only been available since > v1.0.33. > > This update has been tested using qemu_riscv64_virt_defconfig and > the Buildroot host QEMU. > > Signed-off-by: Mark Corbin > --- > Changes v1 -> v2: > - use BR2_RISCV_64 instead of (BR2_riscv && BR2_ARCH_IS_64) > (Thomas P) > --- > package/uclibc/Config.in | 1 + > toolchain/toolchain-buildroot/Config.in | 13 +++++++------ > 2 files changed, 8 insertions(+), 6 deletions(-) Applied to master, thanks. Romain: in the end, I didn't change the existing defconfigs. We usually don't change/check them when we update gcc, glibc or binutils for example. The compiler/C library is pretty much independent from the specific board, so I didn't think it was worth changing the HiFive Unleashed board to use glibc. Thomas -- Thomas Petazzoni, CTO, Bootlin Embedded Linux and Kernel engineering https://bootlin.com